Clementine's Garage
Clementine the Cat
 
Image of flower
Yellow R4
 
Réparateur d'automobiles

in/out-manifold stud-bolts R5Alpine/Gorde (atmo)

reidalpine

Enthusiast
Messages
1,653
Hi guys!
Anyone have the orig pts.No for the stud bolts to bolt on both intake and exhaust-manifold to head on the R1223 motor ?
-Best would be if someone could scan the sparepart page as i think they will also be mentioned by lenght and numbers needed..
Some lost or not there when I got the motor,so haven't a clue how long they should be (there are at least two diff.lenght...
Thanx in advance /-Reid.
 
Last edited:
Inlet manifold is held on with bolts of two different lengths: 77 03 001 693 (40mm) and 77 03 009 104 (35mm). These are standard M8 bolts, no need to search them as genuine spare parts.
Exhaust manifold stud part numbers are 77 03 027 076 (30mm) and 77 03 027 082 (25mm). Again, this is standard M8 hardware, a bit harder to find than bolts, but not "introuvable".
There is no mention on the parts book for the quantity of each needed, nor their location, unfortunately.
 
HI Angel-
Thanx Much for that! I seem to have a mish-mash of lenghts,so will sort it out.
I think the shorter ones is to be used at the rearmost position (1 inlet and 1 exhaust side) due to tighter space.
-Hope you are all ok over there in Athens /-Reid.
 
Last edited:
Back
Top