AndyMcDonnell
Enthusiast
- Messages
- 18
- Location
- Spain
Hi everyone, tidying up in engine bay and I’m asking for some advice, photo or part number of item I need to fit to the headlamp units I have installed. Attached are 5 photos. Photo 1 are the covers that were installed, held on by string into self tapping screws on either side of the unit. They are too small in circumference and depth hitting the electrical connector. They provide no weather proofing and just fall off. Photos 2 and 3 are my actual lights - there is the lip of a rubber seal left on each - did this once have a rubber back that weather proofed the unit? Photo 4 is the Haynes manual and I cannot see how that attaches to my current head lights or where the cover spring 16 would fit into the bonnet. Photo 5 is the units offered by part supplier Franzose in Germany but again I cannot see how they attach? Can someone advise - a photo of what I should have fitted would help greatly. Thank you, Andy.