Hoses to Zenith 32IF 7

[Tomcat]

Looking for the 2 water hoses to the base of the Zenith 32IF 7 as shown in attached picture.
These seem to be preformed and I have looked on MRP & Der Franzose sites for replacements to no avail.
Do I just use straight hose as best I can? Any comments appreciated. Thanks

 

[Cornish4]

Hi Tom, I reckon the hoses you are looking for are unobtainable now, so I simply tee'd into the heater-hoses, which works very well. These plastic T fittings came from a company called Car Buider Solutions.
Regards Brian

 

[harbourseal]

The heater hoses on my carb. Are pneumatic oil hoses. Work fine and are super strong.

 

[Tomcat]

Hi Tom, I reckon the hoses you are looking for are unobtainable now, so I simply tee'd into the heater-hoses, which works very well. These plastic T fittings came from a company called Car Buider Solutions.
Regards Brian View attachment 22870

Brian
Thank you for confirming what I suspected.
Have used CBS many times in the past so will browse their site.
Regards
Tom

 

[Cornish4]

Hi Tom. It's a while ago I bought these tee fittings, and now I'm not so sure I got them from CBS, sorry, so I'll try to track down where they came from. Oh the joys of getting older
Ah ha, I've found the suppliers, it's AFS, Advanced Fluid Solutions.

Regards Brian.

 

[Tomcat]

Hi Tom. It's a while ago I bought these tee fittings, and now I'm not so sure I got them from CBS, sorry, so I'll try to track down where they came from. Oh the joys of getting older
Ah ha, I've found the suppliers, it's AFS, Advanced Fluid Solutions.

Regards Brian.

Brian Thank you for update. Please you do not have to explain the joys of getting older. At 76 now I can just smile and say "Oh dear"
Luckily I live in a bungalow so never have the problem of being halfway on a staircase not remembering if I was going up or down!!!

 

[Cornish4]

Oh dear, and I thought it was only one The tee pieces I used were 18mm with 10mm take offs. Two more photos to show a bit clearer the set-up.
Regards Brian.