robg
Enthusiast
- Messages
- 46
- Location
- KENT
I am intent on adding a servo to the all drum brakes on my R4 GTL.
To do this I anticipate having to change the master cylinder from a three outlet to a two outlet
used on older models. I assume I can combine the two outlet to one through the servo and split the outlet
front and rear. Is there anything I have overlooked?
Still a relative newcomer to this so any advice would be greatly appreciated.
thanks
To do this I anticipate having to change the master cylinder from a three outlet to a two outlet
used on older models. I assume I can combine the two outlet to one through the servo and split the outlet
front and rear. Is there anything I have overlooked?
Still a relative newcomer to this so any advice would be greatly appreciated.
thanks