Clementine's Garage
Clementine the Cat
 
Image of flower
Yellow R4
 
Réparateur d'automobiles

Front to rear rigid petrol pipe

Messages
658
Location
Cheltenham
#1
Hi All
Can someone remind me of the bore of this pipe? Also, how much do I need for an F6? Any recommendations for material/UK supplier?
Thanks
Andy
 
Messages
195
#2
Hi Andy

I cannot remember the bore size but I took my old one down to Pirtek in Avonmouth a couple of years ago and they made one to measure. Not too much of a trek for you from Cheltenham!

Best Regards

Chris
 
Messages
658
Location
Cheltenham
#3
Hi Chris
Thanks, that's good to know - and, yes, not too far!
Still curious to know what the bore/internal diameter is so I can order some Kunifer pipe ; I can check tomorrow.
Thanks again
Andy
 

angel

Enthusiast
Messages
1,832
Location
Athens, Greece
#8
The original is mild steel, but copper, Kunifer or plastic works as well - or better. The plastic one may not be able to follow closely the two 90 deg. bends needed inside the right hand front chassis members, on the 2CV it follows a straight line along the chassis.
 
Top