Clementine's Garage
Clementine the Cat
 
Image of flower
Yellow R4
 
Réparateur d'automobiles

Front to rear rigid petrol pipe

Andy McGhee

Enthusiast
Messages
1,538
Location
Cheltenham
Hi All
Can someone remind me of the bore of this pipe? Also, how much do I need for an F6? Any recommendations for material/UK supplier?
Thanks
Andy
 
Hi Andy

I cannot remember the bore size but I took my old one down to Pirtek in Avonmouth a couple of years ago and they made one to measure. Not too much of a trek for you from Cheltenham!

Best Regards

Chris
 
Hi Chris
Thanks, that's good to know - and, yes, not too far!
Still curious to know what the bore/internal diameter is so I can order some Kunifer pipe ; I can check tomorrow.
Thanks again
Andy
 
The original is mild steel, but copper, Kunifer or plastic works as well - or better. The plastic one may not be able to follow closely the two 90 deg. bends needed inside the right hand front chassis members, on the 2CV it follows a straight line along the chassis.
 
Back
Top